Avaya 9601 - VLAN Parameters; IEEE 802.1.X Parameters

VLAN parameters
Parameter Type Default
value
Description
L2Q Numeric 0 Specifies 802.1Q tagging mode. Assign one of the
following values:
• 0: Auto
• 1: On
• 2: Off
L2QVLAN Numeric 0 Specifies the 802.1Q VLAN identifier. The range is 0
to 4094.
VLANTEST Numeric 60 Specifies the timer for DHCPOFFER reception on a
non-zero VLAN. The range is 0 to 999.
VLANSEP Numeric 1 Specifies whether to enables the VLAN separation.
Assign one of the following values:
• 0: Disabled
• 1: Enabled
PHY2VLAN Numeric 0 Specifies the VLAN ID for tagged frames on the
secondary Ethernet Interface. The range is 0 to
4094.
IEEE 802.1.x parameters
Parameter
Type Default
value
Description
DOT1XSTAT Numeric 0 Specifies the IEEE 802.1X status for Ethernet
interface. Assign one of the following values:
• 0: Supplicant operation disabled.
• 1: Supplicant operation enabled, but responds only
to received unicast EAPOL messages.
• 2: Supplicant operation enabled, responds to
received unicast and multicast EAPOL messages.
DOT1X Numeric 0 Specifies the IEEE 802.1X operational mode for
Ethernet interface. Assign one of the following
values:
• 0: PAE multicast pass-through without proxy
Logoff.
• 1: PAE multicast pass-through with proxy Logoff.
Table continues…
Configuration through the settings file
62 Administering Avaya 9601/9608/9611G/9621G/9641G/9641GS IP Deskphones SIP August 2015
Comments on this document? infodev@avaya.com