System parameter
name
TLV name Impact
This TLV is ignored if:
• The value of USE_DHCP is "0" and the value of IPADD is not
"0.0.0.0".
• The Application Type is not 1 (Voice) or 2 (Voice Signaling).
• The Unknown Policy Flag (U) is set to 1.
SIP_CONTROLL
ER_LIST
Proprietary Call
Server TLV
SIP_CONTROLLER_LIST will be set to the IP addresses in this
TLV value.
Note:
This parameter cannot be used in an environment where
both SIP deskphones and H.323 deskphones exist.
TLSSRVR and
HTTPSRVR
Proprietary File
Server TLV
TLSSRVR and HTTPSRVR will be set to the IP addresses in
this TLV value.
L2Q Proprietary 802.1 Q
Framing
If TLV = 1, L2Q set to "1" (On).
If TLV = 2, L2Q set to "2" (Off).
If TLV = 3, L2Q set to "0" (Auto).
A check is made as to whether a reset is necessary to obtain a
new IP address due to a change in the values of the parameters
L2Q or L2QVLAN.
This TLV is ignored if:
• The value of USE_DHCP is "0" and the value of IPADD is not
"0.0.0.0".
• The current L2QVLAN value was set by an IEEE 802.1 VLAN
name.
• The current L2QVLAN value was set by a TIA LLDP MED
Network Policy (Voice) TLV.
POE_CONS_
SUPPORT
Proprietary - PoE
Conservation Level
Request TLV
If the value of POE_CONS_SUPPORT is "1",
POE_CONS_MODE is set to the level requested in the TLV.
Configuration through LLDP
70 Administering Avaya 9601/9608/9611G/9621G/9641G/9641GS IP Deskphones SIP August 2015
Comments on this document? infodev@avaya.com
To Next Page
Loading...
