1. When you select ADDR from the Craft Local Procedure Screen, the Static
Addressing Local Procedure screen displays as follows with the prompt Select
address to change.
Static Addressing
Field
Field Value Description
Phone (IPv4) nnn.nnn.nnn.nnn Deskphone IP Address
(IPADD)
Phone (IPv6) hhhh:hhhh::hhhh:hhhh:hh
hh
Deskphone IP Address
(NVIPADDV6)
Call Server nnn.nnn.nnn.nnn or
hhhh:hhhh::hhhh:hhhh:hh
hh
Call Server in use; media
server IP Address
Router (IPv4) nnn.nnn.nnn.nnn Router in use; gateway/
router IP Address
Mask (IPv4) nnn.nnn.nnn.nnn IP network mask
(NETMASK)
HTTP Server nnn.nnn.nnn.nnn or
hhhh:hhhh::hhhh:hhhh:hh
hh
IP Address of HTTP File
Server in use
HTTPS Server nnn.nnn.nnn.nnn or
hhhh:hhhh::hhhh:hhhh:hh
hh
IP Address of HTTPS
(TLS) File Server in use
802.1Q L2Q text string L2Q setting text
description
VLAN ID dddd NVL2QVLAN
VLAN Test ddd VLANTEST
where:
• nnn.nnn.nnn.nnn is the current IP Address in IPv4 format associated with the
specific address information to its left, which could be either a value previously
set by a technician, or the original value of NVIPADD if no previous change
was made,
• hhhh:hhhh:hhhh:hhhh:hhhh is the current IP Address in IPv6 format
associated with the specific address information to its left, which could be either
a value previously set by a technician, or the original value of NVIPADD if no
previous change was made,
• L2Q text string is the text string associated with the current system value of
L2Q where “Auto” = an L2Q value of “0”, “On” = an L2Q value of “1”, and “Off”
= an L2Q value of “2”, and
Changing IP address information
H.323 Installation & Maintenance Guide R6.1 May 2011 43
To Next Page
Loading...
