cursor is moved back and the field contents edited). Once content is entered that
unambiguously identifies the format of the IP address (a decimal point for IPv4, or a colon for
IPv6), the rest of the address entry is set according to that format, as specified in the bullet
lists above.
Local administrative (Craft) procedures menu
Craft procedures allow you to customize the IP Deskphone installation for your specific
operating environment. This section provides a description of each local administrative option
covered in this guide, with references to the pages on which the option appears.
Note:
For touch screen-based deskphones, simply “touching” a line or a softkey produces the
same result as selecting a line or a softkey on non-touchscreen (button-based) IP
Deskphones. Unless otherwise prohibited using administration, an end user can view but
not change most of the parameters associated with Craft procedures. For more information,
see the applicable user guide(s).
Shown As
(this value
always
displays in
English)
Craft Procedure Purpose See
8021X Set 802.1X operational mode Setting the 802.1X Operational Mode on
page 40.
ADDR Address information
programming
Using the pre-installation checklist on
page 42 and Changing IP address
information on page 42.
AGC Enable/disable Automatic Gain
Control
Disabling/enabling automatic gain
control on page 46.
CALIBRATE
SCREEN
Calibrate the touch screen Calibrating the Touch Screen on
page 45.
CLEAR Clear all values to factory
defaults
Clearing the deskphone settings on
page 47.
CONT Adjust the contrast of any
Button Modules and any non-
color deskphones
Adjusting contrast on button modules
and non-color deskphones on
page 48.
DEBUG Enable/disable Debug Mode Disabling/enabling debug mode on
page 49.
GROUP Set the Group Identifier Changing the group identifier on
page 50.
Local administrative (Craft) procedures menu
H.323 Installation & Maintenance Guide R6.1 May 2011 39
To Next Page
Loading...
