Press Restart to proceed with the registration steps covered in the About powering-
up and resetting the deskphone (Dynamic Addressing Process) on page 25.
A restart does not affect user-specified data and settings like Contacts data or the
telephone login and password.
The remainder of the restart procedure depends on the status of the boot and
application files.
Setting or changing the signaling protocol
Note:
When updating local (Craft) procedures from a touchscreen deskphone, touching
the line you want to change or the applicable softkey produces the same result
as selecting a line and pressing the applicable softkey on a non-touchscreen IP
Deskphone.
Use the following procedure to set or change the Signaling Protocol Identifier. A
valid SIG Protocol Identifier is either 0 (default), 1 (H.323), or 2 (SIP).
Note:
Perform this procedure only if the LAN Administrator instructs you to do so.
1. When you select SIG from the Craft Local Procedure Screen, the telephone prompts
you to use the Right and Left navigation arrows to select a setting and displays the
following text:
Sig: text string Choice Selector
where the text string is the wording associated with the current system value of
NVSIG, defined as:
• Default when NVSIG = 0
• H.323 when NVSIG = 1
• SIP when NVSIG = 2
2. To change the setting, press the Right (or Left) navigation arrow to cycle through
the settings.
Depending on the current value, the next sequential text string is selected and
displayed as the setting. For example, if the current value is SIP (2), pressing the
Using Local Administrative (Craft) Options
56 H.323 Installation & Maintenance Guide R6.1 May 2011
To Next Page
Loading...
