Avaya 9608 - Changing SSON Settings

Right arrow changes the value to 0 (default). If the current value is H.323 (1),
pressing the Right arrow changes the value to 2 (SIP).
3. Press Save to store the new setting and redisplay the Craft Local Procedure
screen.
The remainder of this procedure depends on the status of the boot and application
files.
Changing SSON settings
Caution:
Do not perform this procedure if you are using static addressing. Perform this
procedure only if you are using DHCP and the LAN administrator instructs you
to do this.
Note:
When updating local (Craft) procedures from a touchscreen deskphone, touching
the line you want to change or the applicable softkey produces the same result
as selecting a line and pressing the applicable softkey on a non-touchscreen IP
Deskphone.
Use the following procedure to set the Site-Specific Option Number (SSON).
1. When you select SSON from the Craft Local Procedure Screen, the following text
displays:
Current setting:
New Setting:
where the setting is the current system value of NVSSON.
2. To change the setting, use the dialpad to enter a valid SSON value between 128
and 255.
3. Press Save to store the new setting and redisplay the Craft Local Procedure
screen.
Changing SSON settings
H.323 Installation & Maintenance Guide R6.1 May 2011 57