The telephone displays the following text:
Clearing values...
The telephone is cleared to its “out of the box” state, resetting the following values
to their factory defaults:
• All system values and system initialization values.
• 802.1X identity and password.
• User options, parameter settings, identifiers and password.
• Any user data like Contact Lists or Call Logs are deleted.
After clearing the values, the telephone resets.
Adjusting contrast on button modules and non-color
deskphones
Note:
When updating local (Craft) procedures from a touchscreen deskphone, touching
the line you want to change or the applicable softkey produces the same result
as selecting a line and pressing the applicable softkey on a non-touchscreen IP
Deskphone.
Use the following procedure to adjust the contrast of any Button Module when
attached to any 9600 Series IP Deskphone or any non-color IP Deskphone. (The
9611G, 9621G, and 9641G each have a color display, and contrast adjustment is
not applicable.) Fifteen contrast levels are available.
1. When you select CONT from the Craft Local Procedure Screen, the telephone
prompts you to use the Right and Left navigation arrows to change the (shown as
Module: 1) or the telephone (shown as Phone:) contrast.
2. To change the setting, press the Right (or Left) navigation arrow to cycle through
the settings.
The factory default setting is the middle setting.
As you press the navigation arrow the next higher or lower contrast level is selected
and displayed as the setting.
Using Local Administrative (Craft) Options
48 H.323 Installation & Maintenance Guide R6.1 May 2011
To Next Page
Loading...
