Completing the power connection
1. Plug one end of the H4DU 4-conductor coiled handset cord into the phone and the
other end into the handset.
2. Plug one end of the first Category 5 modular line cord into the Ethernet jack of the
PC and the other end into the secondary Ethernet jack on the phone, if
appropriate.
3. If the deskphone is to be IEEE-powered, plug one end of the second Category 5
modular line cord into the Ethernet jack on the phone.
Plug the other end of this cord into the Ethernet wall jack. You are now finished. Do
not proceed to Step 4.
4. If the deskphone is to be powered locally, connect the Category 5 modular line cord
provided with the IP Phone Single Port PoE Injector (SPPOE-xx, where xx
represents the model number) into the Ethernet jack on the phone. Plug the femite
end of this cord into the deskphone. Plug the other end of this cord into the SPPOE-
xx power injector jack labeled DATA & POWER OUT. Plug another Category 5 cord
into the SPPOE-xx power injector jack labeled DATA IN. Plug the other end of this
cord into the Ethernet wall jack. Finally, connect the SPPOE-xx to an AC power
source.
Installing a Dual Headset Adapter (DHA)
As of software Release 6.1, a Dual Headset Adapter (DHA) is available for
installation on call center deskphones. The DHA allows a supervisor to monitor calls
in progress and can be attached either directly to a 9641G, 9611G, or 9608
deskphone or to an attached button module. The 9621G does not support a
DHA.
Order the 9600 Dual Headset Adapter Kit (PK25) (Comcode 700500729), which
includes dual headset adapters and required cables for 25 deskphones. Illustration
A shows the DHA Package Contents. The remaining illustrations show how to install
a DHA directly to the deskphone and (alternately) to an attached button module.
Completing the power connection
H.323 Installation & Maintenance Guide R6.1 May 2011 19
To Next Page
Loading...
