Accessing Craft procedures during startup
1. During deskphone startup, invoke local procedures by pressing * to display the Craft
Access Code Entry screen:
Enter code:__
# = OK
2. Enter the local dialpad procedure password (0 to 7 numeric digits), as specified by
the system administrator in the system value PROCPSWD.
For security purposes, the telephone displays an asterisk for each numeric dialpad
press. If you are using a touchscreen deskphone, and need to backspace during
password entry, use the Contacts button; for non-touchscreen phones, use the left
arrow button or the designated softkey.
3. Press # when the password entry is complete.
The entry is compared to the PROCPSWD value. If they match, the telephone
displays the Craft Local Procedure screen, and the prompt “Select procedure and
press Start.”
4. For all non-touchscreen phones, use the navigation arrows to scroll to and highlight
the local procedure you want, then press Start or OK.
Or scroll to the procedure you want and press the corresponding line button. For
touchscreen phones, scroll to the local procedure you want if it not already displayed
then touch the line on which the local procedure you want appears.
Accessing Craft procedures during normal operation
1. Invoke all local procedures by pressing the Mute button, entering the local (dialpad)
procedure password (0 to 7 numeric digits), then pressing the # button.
If you are using a touchscreen phone and need to backspace during password entry,
use the Contacts button; for non-touchscreen phones, use the left arrow button or
the designated softkey.
A six second time-out is in effect between button presses after pressing the Mute
button. If you do not press a valid button within 6 seconds of pressing the previous
Accessing Craft procedures during startup
H.323 Installation & Maintenance Guide R6.1 May 2011 35
To Next Page
Loading...
