Performing a self-test
Note:
9600 Series IP Deskphones store two software code images in reprogrammable
non-volatile memory. The primary image, called the “big app” must be running to
perform a self-test. The backup image, called the “little app” does not support the
self-test.
Note:
When updating local (Craft) procedures from a touchscreen deskphone, touching
the line you want to change or the applicable softkey produces the same result
as selecting a line and pressing the applicable softkey on a non-touchscreen IP
Deskphone.
For self-testing, use the following procedure:
1. When you select TEST from the Craft Local Procedure Screen, the telephone
displays the following text:
Press Test to confirm.
2. Press Cancel to return to the Craft Local Procedure screen without testing the
telephone.
Press Test to start telephone testing.
The test performs the following actions:
• All softkeys are unlabeled.
• Groups of no more than 13 LEDs at a time on the telephone and any attached
button modules illuminate sequentially for about a half second. Illumination
starts with the upper half of the telephone and continues through the lower half
of any attached button module in a repeating cycle.
• Pixels on the display are shown at their highest intensity.
After approximately 5 seconds, the top Application line displays either “Self-
test passed” or “Self-test failed.”
3. Press Back to return to the Craft Local Procedure screen.
Using Local Administrative (Craft) Options
58 H.323 Installation & Maintenance Guide R6.1 May 2011
To Next Page
Loading...
