Disabling/enabling event logging
Note:
When updating local (Craft) procedures from a touchscreen deskphone, touching
the line you want to change or the applicable softkey produces the same result
as selecting a line and pressing the applicable softkey on a non-touchscreen IP
Deskphone.
Use the following procedure to enable or disable logging of system events.
1. When you select LOG from the Craft Local Procedure Screen, the telephone
prompts you to use the Right and Left navigation arrows to select a setting and
displays the following text:
Log: text string Choice Selector
where the text string is the wording associated with the current system value of
NVLOGSTAT, defined as:
• Disabled when NVLOGSTAT = 0
• Emergencies when NVLOGSTAT = 1
• Alerts when NVLOGSTAT = 2
• Critical when NVLOGSTAT = 3
• Errors when NVLOGSTAT = 4
• Warnings when NVLOGSTAT = 5
• Notices when NVLOGSTAT = 6
• Information when NVLOGSTAT = 7
• Debug when NVLOGSTAT = 8
2. To change the setting, press the Right (or Left) navigation arrow to cycle through
the settings.
Depending on the current value, the next sequential text string is selected and
displayed as the setting. For example, if the current value is Alerts (2), pressing the
Right navigation arrow changes the value to Critical (3). If the current value is Debug
(8), pressing the Right navigation arrow changes the value to Disabled (0).
3. Press Save to store the new setting and redisplay the Craft Local Procedure
screen.
Using Local Administrative (Craft) Options
52 H.323 Installation & Maintenance Guide R6.1 May 2011
To Next Page
Loading...
