1. When you select INT from the Craft Local Procedure Screen, the following text
displays with a prompt to use the Right and Left navigation arrows to select a setting:
Ethernet Choice Selector
PC Ethernet Choice Selector
The values shown are the text strings associated with the current PHY1STAT on
the Ethernet line and the current PHY2STAT system value on the PC Ethernet
line.
The PHY1STAT text strings are:
• Auto when PHY1STAT = 1
• 10Mbps half when PHY1STAT = 2
• 10Mbps full when PHY1STAT = 3
• 100Mbps half when PHY1STAT = 4
• 100Mbps full when PHY1STAT = 5
• 1000Mbps full when PHY1STAT = 6
The PHY2STAT text strings are:
• Disabled when PHY2STAT = 0
• Auto when PHY2STAT = 1
• 10Mbps half when PHY1STAT = 2
• 10Mbps full when PHY1STAT = 3
• 100Mbps half when PHY1STAT = 4
• 100Mbps full when PHY1STAT = 5
• 1000Mbps full when PHY1STAT = 6
2. To change the Ethernet setting, press the Right navigation arrow to cycle through
the possible settings.
Depending on the current value, the next sequential text string is selected and
displayed as the setting. For example, if the current value is 10Mbps half (2),
pressing the Right navigation arrow changes the value to 10Mbps full (3). If the
current value is 1000Mbps full (6), pressing the navigation arrow changes the value
to Auto (1).
3. To change the PC Ethernet setting, select that line and press the Right navigation
arrow to cycle through the possible settings.
4. Press Save to store the new setting(s) and redisplay the Craft Local Procedure
screen.
Changing Ethernet interface control
H.323 Installation & Maintenance Guide R6.1 May 2011 51
To Next Page
Loading...
