Changing the group identifier
Note:
When updating local (Craft) procedures from a touchscreen deskphone, touching
the line you want to change or the applicable softkey produces the same result
as selecting a line and pressing the applicable softkey on a non-touchscreen IP
Deskphone.
Use the following procedure to set or change the Group Identifier.
Note:
Perform this procedure only if the LAN Administrator instructs you to do so. For
more information about groups, see Applying settings to logical groups on
page 63.
1. When you select GROUP from the Craft Local Procedure Screen, the following text
displays:
Current Setting:
New Setting:
where the setting is the current system value of NVGROUP.
2. Enter a valid Group value (0-999).
3. Press Save to store the new setting and redisplay the Craft Local Procedure
screen.
Changing Ethernet interface control
Note:
When updating local (Craft) procedures from a touchscreen deskphone, touching
the line you want to change or the applicable softkey produces the same result
as selecting a line and pressing the applicable softkey on a non-touchscreen IP
Deskphone.
Use the following procedure to set or change the interface control value.
Using Local Administrative (Craft) Options
50 H.323 Installation & Maintenance Guide R6.1 May 2011
To Next Page
Loading...
