3. If more than one button module is attached, scroll down to that line, for example, to
Module: 2 and repeat Step 2 to change the contrast.
4. Press Save to store the new contrast setting(s) and redisplay the Craft Local
Procedure screen.
Disabling/enabling debug mode
Note:
When updating local (Craft) procedures from a touchscreen deskphone, touching
the line you want to change or the applicable softkey produces the same result
as selecting a line and pressing the applicable softkey on a non-touchscreen IP
Deskphone.
Use the following procedure to turn the debug mode for the button module serial
port on or off.
Caution:
The default DEBUG setting is “Off” which enables button module operation. A
DEBUG setting of “On” disables any button module connected to the module
interface or any adapter plugged into Slot 2.
1. When you select DEBUG from the Craft Local Procedure Screen, the following text
displays:
Debug Mode On
where the setting is the text string associated with the current system value of
NVDEBUG, defined as:
• “On” if the NVDEBUG system value is “1”.
• “Off” if the NVDEBUG system value is “0”.
2. Press Change to toggle the selected setting from On to Off or vice versa.
3. Press Save to store the new setting.
The telephone saves the new value and the telephone initiates a reset.
Disabling/enabling debug mode
H.323 Installation & Maintenance Guide R6.1 May 2011 49
To Next Page
Loading...
