To enable external WebRTC clients, the same interface must be configured for the TURN
server as the A1 interface.
8. In Service Type, select TURN.
9. Click Finish.
Next steps
Add Avaya SBCE to the Avaya Aura
®
Web Gateway.
Adding Avaya Session Border Controller for Enterprise to the
Avaya Aura
®
Web Gateway
Procedure
1. Log in to the Avaya Aura
®
Web Gateway web administration portal.
2. Click Add to add a new Avaya SBCE or click Edit to update the information for the existing
Avaya SBCE connection.
3. In SIP Address, type the FQDN or IP address of the internal A1 interface of the Avaya
SBCE that is used for SIP signaling to interact with Avaya Aura
®
Web Gateway.
For more information, see External native clients media configuration on page 128.
4. In IP Port, enter 5061.
5. In SIP Protocol, select TLS.
6. In HTTP Address, type the internal Avaya SBCE FQDN specified for the load monitoring
entry.
For example: asbce_management.company.com.
7. In HTTP Port, enter 443.
8. In HTTP Protocol, select https.
9. In Location, specify the location of the Avaya SBCE server.
10. Click Save.
Next steps
If you have conferencing, add Avaya SBCE to Avaya Equinox
®
Conferencing Management.
Adding Avaya Session Border Controller for Enterprise to Avaya
Equinox
®
Conferencing Management
Procedure
1. Log in to the Avaya Equinox
®
Management web administration portal.
Avaya Session Border Controller for Enterprise configuration
October 2018 Deploying the Avaya Aura
®
Web Gateway 122
Comments on this document? infodev@avaya.com
To Next Page
