Avaya Aura - Chapter 3: Deployment process; Configuration worksheet

Chapter 3: Deployment process
The following table shows the high-level tasks for deploying the Avaya Aura
®
Web Gateway
High-level tasks Notes
Perform planning and site preparation tasks. See Planning checklist on page 23.
As part of the site preparation, you must set up the
required infrastructure components in your network.
Avaya Aura
®
is required in Team Engagement
deployments. Your deployment can also include
Conferencing.
Complete initial setup and installation. You must deploy the OVA for the VMware or AWS
environment before you can install the Avaya Aura
®
Web Gateway software.
See Deployment process checklist on page 42.
Perform configuration. Perform the appropriate configuration tasks for each
deployment option. For more information, see
Configuration worksheet on page 20.
Configuration worksheet
Use this checklist to determine the configuration requirements for each deployment type. The
deployment types are:
• Single FQDN, single data center.
• Multiple FQDNs, single data center.
• Multiple data centers, which is also known as geographical distribution.
The deployment option with multiple data centers requires multiple FQDNs. With this deployment,
you require at least one FQDN for each service.
Task
Single FQDN, single
data center
Multiple FQDNs, single
data center
Multiple data centers
Configure a global
FQDNs. See Global
—
Table continues…
October 2018 Deploying the Avaya Aura
®
Web Gateway 20
Comments on this document? infodev@avaya.com