Avaya Aura - Seed Node Replacement Configuration

To Next Page

To Previous Page

9. Select Continue to start the configuration utility.

Important:

Do not change the settings in Front-end host, System Manager and Certificate

Configuration without reentering the System Manager enrollment and keystore

passwords before applying the changes.

Warning:

Do not configure the LDAP settings on nodes that you add to a cluster. The LDAP

configuration is automatically configured for additional nodes when they connect to the

initial node.

10. If this is the second node of a cluster and use of virtual IP for internal load balancing is

enabled on the initial node, then do the following:

Important:

The virtual IP must be enabled only for the initial node and the second node. Do not

enable the virtual IP on any other nodes.

a. Select Clustering Configuration > Virtual IP Configuration.

b. Select Enable virtual IP and set the value to y (yes).

The system displays additional Virtual IP configuration.

c. Configure all of the Virtual IP settings as described in Virtual IP configuration

options on page 91.

Important:

You must use the same Virtual IP authentication password that you set on the

initial node of the cluster.

d. To save the changes on the system, select Apply and then select Continue.

e. Select Return to Main Menu and press Enter.

11. To apply the changes, from the main menu, select Continue and then select Yes to start

the services.

The system starts the services.

12. To exit the configuration tool, select Continue.

Next steps

• Set up the required certificates as described in Certificate configuration using the

configuration utility on page 148.

• Repeat this procedure to add the required number of nodes to the cluster.

• After all of the required cluster nodes are installed or if new nodes are added to an existing

cluster, you must configure the RSA public and private keys on the initial node.

Related product manuals