Avaya Aura - Configuring Avaya Session Border Controller for Enterprise server flows

8. To configure a policy group using the newly created application and media rules, navigate
to Domain policies > End Point Policy Groups , create a new group, and add the
required application and media rules to that group.
Configuring Avaya Session Border Controller for Enterprise server flows
Before you begin
Ensure that you have the TLS client profile created when you configured a certificate authority for
reverse proxy. For more information, see
Certificate Authority configuration checklist on page 113.
An example of the TLS client profile name is certficateAuthorityTlsProfile.
Procedure
1. Log in to the Avaya SBCE web administration portal.
2. To create an interworking profile, do the following:
a. Navigate to Global Profiles > Server Interworking and then select Add.
b. For the new profile, use the default options for all settings.
c. In the Advanced Options section, set Has Remote SBC to No (disabled).
3. To add a configuration for Avaya Equinox
®
Management, do the following:
a. Navigate to Global Profiles > Server Configuration and then click Add.
b. From Sever Type, select Trunk Server.
c. Leave SIP domain blank.
d. From TLS Client Profile, select the TLS client profile that you created when you
configured a certificate authority for reverse proxy.
e. Add the Avaya Equinox
®
Management FQDN with port 5061 and the TLS protocol
specified.
f. In the Advanced Options section, select the Enable Grooming check box and then
select the previously created interworking profile.
4. To add a configuration for the Avaya Aura
®
Web Gateway, do the following:
a. Navigate to Global Profiles > Server Configuration and then click Add.
b. From Sever Type, select Trunk Server.
c. Leave SIP domain blank.
d. From TLS Client Profile, select the TLS client profile that you created when you
configured a certificate authority for reverse proxy.
e. Add the Avaya Aura
®
Web Gateway FQDN with port 5061 and TLS protocol specified.
f. Repeat the previous substep for FQDNs of all Avaya Aura
®
Web Gateway nodes.
g. In the Advanced Options section, select the Enable Grooming check box and then
select the interworking profile created in the previous step.
Avaya Session Border Controller for Enterprise configuration
October 2018 Deploying the Avaya Aura
®
Web Gateway 134
Comments on this document? infodev@avaya.com