Avaya Aura - Page 75

Item name Description Equivalent
installation.properties file
parameter
Avaya Aura
®
Web Gateway on the
reverse proxy port. Clients within the
enterprise continue to access Avaya
Aura
®
Web Gateway directly using port
443.
Select y (yes) to configure the port for
the reverse proxy server or n (no) to
keep the default configuration that
remains disabled.
Important:
If this setting is enabled, you cannot
set the port to 443, but you can set
it to 8444, which is the default
setting, or to any other port.
If you select y (yes), the menu displays a
new setting for the reverse proxy port:
Front-end port for reverse proxy.
If you override the port for remote
access, you must configure this port on
the Avaya SBCE external interface for
Avaya Aura
®
Web Gateway. For more
information, see Administering Avaya
Session Border Controller for Enterprise.
Note:
You can also set this port on the
Avaya Aura
®
Web Gateway
administration portal under External
Access > HTTP Reverse Proxy.
After selecting the Front-end port
for remote access check box, you
can modify the port value.
Use System
Manager for
certificates
Specifies if the certificates are retrieved
from Avaya Aura
®
System Manager or
from imported files.
Select y (yes) to retrieve certificates from
Avaya Aura
®
System Manager or n (no)
to retrieve certificates from imported files.
If you select n (no), the menu displays
new settings for configuring the
certificate files. To configure the
USE_SMGR
If the USE_SMGR option is set to n (no),
you must configure the following
parameters for importing the certificate
files:
•
REST_KEY_FILE
•
REST_CRT_FILE
•
SIP_KEY_FILE
•
SIP_CERT_FILE
Table continues…
Avaya Aura
®
Web Gateway initial configuration settings
October 2018 Deploying the Avaya Aura
®
Web Gateway 75
Comments on this document? infodev@avaya.com