Avaya Aura - Page 92

Option Description Equivalent
installation.properties file
parameter
These settings are listed below in this
table. If you are performing a silent
installation you must also configure these
parameters in the
installation.properties file.
Virtual IP address The virtual IP address shared by all the
cluster nodes.
KA_VIRTUAL_IP
Virtual IP
interface
The network interface used for the virtual
IP address. Unless you are using a
configuration that has multiple Ethernet
interfaces, you must set this value to eth0
(Ethernet-zero).
KA_INTERFACE
Virtual IP master
node
Determines if the current node is the
virtual IP master node. As the initial node
of the cluster is usually designated the
virtual IP master, set this value to y (yes),
on the initial node. In addition, as the
second node in a cluster is usually
designated the virtual IP backup, set this
value to n (no) on the second node.
KA_MASTER_YN
Virtual IP router
ID
An integer with a value from 1 to 255. The
value must be the same for both virtual IP
master and backup. The default value is
71.
This value must be unique across Virtual
Router Redundancy Protocol (VRRP)
installations.
KA_ROUTER_ID
Virtual IP
authentication
password
The password that the backup node uses
for authentication. This password must be
the same as the virtual IP authentication
password configured for the initial node.
KA_AUTHENTICATION_PASSWORD
Related links
Avaya Aura Web Gateway initial configuration settings on page 73
Avaya Aura
®
Web Gateway setup
October 2018 Deploying the Avaya Aura
®
Web Gateway 92
Comments on this document? infodev@avaya.com