USB Audio/Video Bar Mode
When USB Audio/Video Bar mode is active, you can use an Avaya CU360 device as your laptop’s
external camera, microphone, and speaker.
With USB A/V bar mode active, users can run their preferred software based unified
communications or video conferencing application on their computer and use the device’s
embedded camera and audio in/out.
Connect the CU360 to the computer
USB Audio/Video Bar Mode can be activated on CU360 once a computer is connected to the
CU360 device through a USB 3.0 cable (connected to CU360 type-C port) and the computer is
detected.
Figure 35: How to use CU360 as USB A/V Bar
If the computer is detected by the CU360, a message will be shown on the CU360 App page, and
an icon will appear on the CU360 App top info-bar. The icon for Control Camera will also change.
Figure 36: Computer connected via USB 3.0 to CU360
• Important
• To be supported, your laptop must have one of the following operating systems:
Windows 10 version 1803 or later. Apple macOS is not supported in this build.
• If your laptop is not detected, assure that you are using a USB 3.0 cable
connected to CU360’s type-C port.If you need a cable longer than 2.7 m (8.8 ft),
use an active USB booster extension cable. Don’t use a cable suitable only for
charging devices.It is strongly suggested to not plug an USB extra camera to
the CU360 if you plan to use the CU360 itself as USB Camera.
To Next Page
Loading...
