Activate USB A/V Bar Mode
To activate USB Bar mode, once your laptop has been detected, press the Control camera button
on the system UX (GUI or web) or the proper remote-control key (see below pictures).
The CU360 supports 1080p30 video when used as a USB camera.
If you want to extend the laptop configuration to include an external monitor with this setup,
connect your computer to the monitor in your usual way.
• Important
• If you plan to use the CU360 in USB Bar Mode only, without connecting any
monitor to it, it is strongly suggested to configure the CU360 in restricted Access
Mode. See Restricted Access Mode..The remote-control key can be used
to easily toggle USB Bar Mode when the CU360 is not connected to a monitor.
Once USB Bar mode is active, the LEDs around CU360 camera will become green.
Figure 39: USB A/V Bar Mode Active – Green LEDs around the Embedded Camera
To Next Page
Loading...
