Figure 46: USB A/V Bar Mode Active – Web
The remote-control key can be used to easily stop USB Bar Mode even when the CU360 is
not connected to a monitor. As an alternative, press on the Exit buttons on the UX/Web interface
• Caution
• Do not unplug the USB type-C cable from the PC while the USB Bar mode is
active. In some cases, this could cause the CU360 to hang or reboot.
Camera Track Mode with Auto Framing
In this release, in addition to the possibility to track the active speaker in front of the device with
the embedded camera, it is also possible to activate the automatic framing for the CU360 App.
The automatic framing recognizes the people sitting in front of the device by their faces and finds
the best framing to include all of them.
See Auto Framing section.
Support for Avaya HC010 USB Camera
You can connect an external USB camera, officially supported for Avaya XT Series (Logitech
C920, C930e or Avaya HC020/HC050 and now the latest Avaya HC010) to the CU360 device.
To enable an additional USB camera, browse to
[GUI] CONFIGURE > ADVANCED > I/O CONNECTION> CAMERAS> USB
[WEB] [ADMIN LOGIN] ADMINISTRATOR SETTINGS> I/O CONNECTION> CAMERAS> USB
• Enable: Yes*/No
• Control Camera: Yes/No*
Figure 47: How to Enable a USB camera as Additional Camera
The USB cameras are opened at up to 720p@30 in this release and can be used as an additional
live camera in the CU360 app.
Presets for the USB camera can be saved and recalled.
To Next Page
Loading...
