• It is suggested to connect the PC or mobile/tablet before placing a call, or use an
Ethernet cable to connect your CU360 Device to the network
Connect to Wi-Fi Display (Miracast) from Windows 10 PC
To connect a Windows PC supporting Wi-Fi Display to your CU360, do the following
- Launch the CU360 Wi-Fi Display app as explained in the “CU360 as Wi-Fi Display”
section.
- On your Windows PC, click on the Notification Icon present on the Tray Bar, and select
“Connect”
- Check if Miracast is supported
- If it is supported, click on your CU360 Name (as a Display)
- Once connected, the Windows PC will see your CU360 device as and additional monitor
(second, third…) at 1080p@30fps, where to extend or duplicate the PC desktop.
- Using the “Project” tab on the PC, you can change PC the desktop projection mode:
o Duplicate, Extend, …
To Next Page
Loading...
