Related links
The front panel of the Branch Gateway chassis without media modules on page 111
Switch ports (ETH LAN)
Each ETH LAN port is a standard RJ-45 network port. Use ETH LAN to connect a data device to the
switch through a 10/100 Mbps Ethernet port. You can connect an external LAN to ETH LAN.
Related links
The front panel of the Branch Gateway chassis without media modules on page 111
RST and ASB buttons
RST is the reset button. ASB is the Alternate Software Bank button.
The Branch Gateway has two firmware banks:
• Bank A
• Bank B
Each firmware bank contains a version of the Branch Gateway firmware. These may be different
versions. The purpose of this feature is to provide software redundancy. If one of the versions
becomes corrupted, you can reset the Branch Gateway using the other version. This is particularly
important when uploading new versions.
By default, when you turn on or reset the Branch Gateway, the Branch Gateway loads firmware from
Bank B. This default setting can be changed by the system administrator.
For example, if the Branch Gateway is configured to load firmware from Bank B, you can reset the
Branch Gateway to load the firmware from Bank A instead.
Related links
The front panel of the Branch Gateway chassis without media modules on page 111
Loading firmware from a bank other than the default bank during startup on page 115
Loading firmware from a bank other than the default bank during startup
Procedure
1. Press and hold the reset button.
2. Press and hold the ASB button.
3. Release the reset button.
4. Release the ASB button.
Related links
RST and ASB buttons on page 115
Front panel description
February 2017 Installation and Upgrades for the Avaya Branch Gateway G430 115
Comments on this document? infodev@avaya.com
To Next Page
