register the system in the Automatic Registration Tool (ART). Provision the IP Address for
S8300 Remote Access with Configure server by using the Set Modem Interface function. Non-
Avaya personnel may need to contact their service support or customer care center for IP
addresses, depending on entitlements.
Related links
Before going to site on page 10
Obtaining the RAS IP address and password on page 14
Obtaining the RAS IP address and password
Procedure
1. Access the ART website on your laptop.
2. From the User menu, select Administer an S8xxx, Gxxx, CCS, CVLAN, or ASG Guard II.
The Enter Network Password dialog box appears.
3. Enter your ART user name and password.
4. Click OK.
The Start of Installation script & IP Addr Admin screen appears.
5. In the FL Number field, enter the customer’s FL number.
6. In the Session Type field, select Installation Script Administration.
7. In the Product Type field, select Gxxx MEDIA GATEWAY if you want to configure remote
access for the Branch Gateway, or S8300 SERVER if you want to configure remote access
for the S8300.
8. In the INADS field, enter the number of the telephone line to which you will connect the
modem.
9. Click Start Installation script & IP Addr Admin.
ART validates your input and the Customer Validation screen appears.
10. Read the customer information displayed, to check that it is correct.
11. In the Customer Type field, select Other.
12. Click Continue Installation Script Administration.
A product list appears.
13. Click the number of the product for which you are configuring remote access.
The Gxxx MEDIA GATEWAY Installation Script Administration Data screen appears.
14. In the Product Name field, enter the product name.
15. In the INADS Number field, make sure the correct customer provided dial-in number for the
Branch Gateway appears.
16. Click Continue Installation Script Administration.
Before you install
February 2017 Installation and Upgrades for the Avaya Branch Gateway G430 14
Comments on this document? infodev@avaya.com
To Next Page
