Downgrading from a compact flash to internal flash memory
About this task
You can downgrade from using up to 1024 announcements on a compact flash to using up to 256
announcements on the internal flash.
Important:
The internal flash can only store up to 256 announcement files, totaling no more than 45
minutes.
Procedure
1. Backup the announcements from the compact flash to a USB device by entering the CLI
command backup config usb usb-devicebackup-name announcements-
compact-flash.
Note:
If you have only a few announcement files, you can use the CLI command copy
announcement-file usb to copy them one by one.
2. At the SAT interface of the Communication Manager, enter disable announcement-
board, and then set enable CF to n in the change media-gateway screen.
Important:
Make sure the yellow CARD IN USE LED associated with the compact flash is not
flashing.
Important:
If a compact flash is removed while it is in use, the announcement files on the compact
flash may become corrupted and the Branch Gateway may reset, causing all
announcement files in RAM to be lost.
3. Remove the compact flash memory card.
4. Optionally replace the 512 MB RAM card with the 256 MB RAM card (see Replacing a RAM
card on page 80).
5. At the SAT interface of the Communication Manager, enter enable announcement-
board.
6. Make sure there are no more than 256 announcement files in the backup.
If the number of announcement files exceeds 256, manually delete as many as necessary in
the backup directory.
7. Restore the announcements from the USB device to internal flash by entering the CLI
command restore usb usb-devicebackup-name announcements-internal-
flash.
Field Replaceable Unit upgrades and replacements
February 2017 Installation and Upgrades for the Avaya Branch Gateway G430 85
Comments on this document? infodev@avaya.com
To Next Page
Loading...
