Swapping compact flash memory cards on page 84
Replacing a compact flash memory card while retaining the current announcements on page 84
Downgrading from a compact flash to internal flash memory on page 85
Swapping compact flash memory cards
Procedure
1. At the SAT interface of the Communication Manager, enter disable announcement-
board.
Important:
If you do not enter the SAT command disable announcement-board, then, when
you insert the new compact flash, its contents will be overwritten by the contents of the
old compact flash.
2. Make sure the yellow CARD IN USE LED associated with the compact flash is not flashing.
Warning:
If a compact flash is removed while it is in use, the announcement files on the compact
flash may become corrupted and the Branch Gateway may reset, causing all
announcement files in RAM to be lost.
3. Remove the compact flash memory card.
4. Insert the new compact flash memory card into the compact flash slot.
5. At the SAT interface of the Communication Manager, enter enable announcement-
board.
Related links
Compact flash memory card removals on page 83
Replacing a compact flash memory card while retaining the current announcements
Procedure
1. Make sure the yellow CARD IN USE LED associated with the compact flash is not flashing.
Important:
If a compact flash is removed while it is in use, the announcement files on the compact
flash may become corrupted and the Branch Gateway may reset, causing all
announcement files in RAM to be lost.
2. Remove the compact flash memory card.
3. Insert the new compact flash memory card into the compact flash slot.
The announcement files of the old compact flash are written to the new compact flash.
Related links
Compact flash memory card removals on page 83
Upgrading and replacing Field Replaceable Units
February 2017 Installation and Upgrades for the Avaya Branch Gateway G430 84
Comments on this document? infodev@avaya.com
To Next Page
Loading...
