Related links
User mailbox configuration on page 20
User Voicemail Settings
Name Description
Voicemail Code Default = Blank, Range = 0 (no code) to 15 digits.
This field sets the mailbox access code. This code is required for access to the
mailbox from any source that is not a trusted location.
If remote access is attempted to a mailbox that has no voicemail code set, the
prompt, “Remote access is not configured on this mailbox” is played.
If password enforcement has been enabled for the system, the voicemail code
cannot:
• be the same as the extension number
• be the same as the previous code
• contain any consecutive digits
• contain repeated digits
• be shorter than the system’s minimum password length setting
Voicemail On Default = On.
When on, calls to the user's number go to voicemail if all not answered within
their No Answer Time or if they have selected Do Not Disturb. Note that
unselecting this option does not disable use of the user's mailbox. Messages
can still be forward to their mailbox and the mailbox can still be accessed to
collect messages.
Voicemail Help Default = Off.
Help can also be accessed by dialing *4 after accessing the mailbox.
Voicemail Ringback Default = Off.
When enabled, and a new message has been received, the voicemail server
calls the user's extension to attempt to deliver the message each time the
telephone is put down. Voicemail will not ring the extension more than once
every 30 seconds. Supported in Intuity emulation mode only.
Voicemail Email
Reading
This setting is not used for embedded voicemail.
UMS Web Services This setting is not used for embedded voicemail..
Table continues…
User mailbox configuration
September 2020 Embedded Voicemail Installation 22
Comments on this document? infodev@avaya.com
To Next Page
Loading...