7. Click OK.
Result
Embedded Voicemail events are now shown in the Monitor trace when running. These events are
all prefixed LVM. Details include the approximate remaining message capacity of the memory card.
156165753mS LVM(housekeeping): FlashMan: FiveMinuteActions: called 2009/01/29
06:52:55
156165796mS LVM(housekeeping): FlashMan: FiveMinuteActions: Free: 426.4 MBytes ( 81% )
156165796mS LVM(housekeeping): 14 Hours 48 Minutes Approx. Remaining
156165796mS LVM(housekeeping): FMML Size: 35
Related links
Mailbox Maintenance on page 65
DTE Port Maintenance
About this task
Using a serial cable, it is possible to perform a range of commands on the system running
embedded voicemail. See the "Installing IP500 V2" manual for details of the cable required and
the serial port settings.
Warning:
• These options should be used with caution. The DTE interface includes other options
that can erase the whole systems software and configuration.
Procedure
1. Connect to the system using a serial cable.
2. Enter AT. The system should respond OK.
3. Enter AT-DEBUG. The system will respond with hello >.
4. Enter ivm-help. The system will respond by listing the mailbox and message commands.
These are:
Choice Option Choice Description
ivm-mbox-show Show the details of all mailboxes.
ivm-mbox-show
nnn
Show the details of the mailbox specified.
ivm-mbox-clear
nnn
Delete all messages, prompts and recordings relating to the mailbox
specified.
ivm-msg-del nnn
yy/mm/dd
hh:mm:ss
Delete all messages in the mailbox extension number specified up to the
date specified. If the date is omitted then all messages are deleted.
ivm-msg-del-all Delete all mailbox messages.
ivm-status-show Show the summary of the embedded voicemail status.
Mailbox Maintenance
September 2020 Embedded Voicemail Installation 68
Comments on this document? infodev@avaya.com
To Next Page
Loading...