Installing IP500/IP500 V2 Page 202
15-601042 Issue 28c (19 August 2013)IP Office 9.0
9.11 Adding External Expansion Modules
External expansion modules connect to the IP Office control unit using an
expansion interconnect cable.
Objective - Connect the external expansion modules and then restart the
control unit so that the new modules are recognized.
Each module is supplied with an expansion connect cable and a power supply unit
.
An appropriate locale specific power cord for the power supply unit, and cables
for the ports on the front of the module must be ordered separately.
· Each external expansion module is supplied with a blue 1 meter (3'3'') expansion interconnect cable. This
cable must be used when connecting to expansion ports on the rear of a control unit.
· When connecting to expansion ports on an IP500 4-Port Expansion card, a yellow 2 meter (6'6") expansion
interconnect cable can be used in place of the standard blue cable. 4 Yellow cables are supplied with the IP500
4-Port Expansion card.
Installation Requirements
· o Installation space either on or under the existing IP Office control unit.
· o Switched power outlet socket.
· o Available EXPANSION port on the control unit.
· o Grounding Requirements
· o Functional Grounding
Connection of a functional earth is:
· o Recommend for all modules.
· o Connection of a functional ground is mandatory for Analog Trunk module.
· o Protective Grounding
Connections of a protective ground via surge protection equipment is:
· o Mandatory for Analog trunk modules in the Republic of South Africa.
· o Mandatory for Digital Station and Phone modules connected to out of building extensions.
· o Mandatory for Digital Station V2 and Phone V2 modules.
Tools Required
· o IP Office Manager PC.
· o Tools for rack mounting (optional).
39
40
42
44
45
204
To Next Page
Loading...
