Installing IP500/IP500 V2 Page 276
15-601042 Issue 28c (19 August 2013)IP Office 9.0
10.9.6 So8
The So8 module is used to add ETSI BRI S0-interface ports to the IP Office system. These ports can then be used for the
connection of ISDN devices.
All IP Office control units except Small Office Edition.
Supported in all IP Office locales .
IP Office core software level 1.0 minimum. Bin file = nas0-16.bin.
Power supply unit (see below) and Expansion Interconnect cable.
The unit is supplied with an earthed 3-Pin, 60W external power supply unit. The PSU has an integral
power cord for connection to the unit's DC I/P socket. A locale specific IEC60320 C13 power cord
for the external PSU is required but is not supplied with the unit.
· Older units were supplied with a 2-Pin, 40W external power supply unit which used a locale
specific locale specific IEC60320 C7 power cord .
The module is designed as a free-standing module that can be stacked on or under other IP Office
modules. The module can be rack mounted in a 19" rack system using the optional IP400 Rack
Mounting Kit.
Width: 445mm/17.5". Depth: 245mm/9.7". Height: 71mm/2.8"/2U.
Unboxed: 2.8Kg/6.3lbs. Boxed: 4.1Kg/9.2lbs.
To Next Page
Loading...
