Avaya IP500 V2 - Analog Trunk Cards (ATM4); BRI Trunk Cards

Installing IP500/IP500 V2 Page 259
15-601042 Issue 28c (19 August 2013)IP Office 9.0
System Components: IP400 Trunk Cards
10.7.2 Analog Trunk Cards (ATM4)
The Analog Trunk card is also referred to as the "ATM4". It provides 4 RJ45 sockets for analog trunk connections . The
card only supports loop-start trunks.
The card is available in a number of locale specific variants as detailed below.
· Power Failure Operation
There are no power failure extension connections provided for the analog trunk card.
· WARNING
In all IP Office installations, any module or control unit using analog trunk connections must be connected to a
functional earth .
· WARNING
Within the Republic of South Africa and in areas of high lightning risk, any module or control unit using analog trunk
connections must be connected to a protective ground and to surge protection equipment .
ATM4 Trunk Cards
Country
SAP Code
IP500
IP500
V2
IP400 Analog 4
(Loop-Start)
North and South
America
700185192
–
–
IP400 Analog 4 EU
(Loop-Start)
Europe
700241672
–
–
IP400 Analog 4 NZ
(Loop-Start)
New Zealand
700241706
–
–
· These cards include two plastic stand off pillars for installation and a replacement blanking plate for the rear of
IP400 control units.
10.7.3 BRI Trunk Cards
The BRI trunk card is also referred to as the "Quad BRI". It provides 4 RJ45 sockets for ETSI BRI trunk connections, with
each trunk supporting 2B+D channels.
Variant
Country
SAP Code
IP500
IP500
V2
IP400 BRI
All
700185168
IP400 BRI 8 (UNI)
All except China
700262017
· The trunk card ports include 100 ohm termination.
· These cards include two plastic stand off pillars for installation and a replacement blanking plate for the rear of
IP400 control units.
· For the IP500 and IP500 V2 control units, an IP500 Carrier Card is required, up to a maximum of 2 IP500 Carrier
Cards.
390
44
44 45