Installing IP500/IP500 V2 Page 247
15-601042 Issue 28c (19 August 2013)IP Office 9.0
System Components: IP500 External Expansion Modules
10.5.4 Digital Station 16A/30A
These modules can be used to add additional TCM ports for TCM phones, for example M-Series and T-Series phones.
The module is available in 16 and 30 port variants, referred to as the IP500 DS16A and IP500 DS30A respectively.
The modules use RJ21 connectors; 1 on the 16 port version, 2 on the 30 port version. For TCM connections using RJ45
port, use the IP500 DS16B/30B modules .
Supported in all IP Office locales .
IP Office Release 7.0 minimum (TCM only). Bin file = nadcpaV1.bin.
Power supply unit (see below) and Expansion Interconnect cable.
The module is supplied with a Earthed 3-Pin, 60W external power supply module. The PSU has an
integral power cord for connection to the module's DC I/P socket. A locale specific IEC60320 C13
power cord for the external PSU is required but is not supplied with the module.
The module is designed as a free-standing module that can be stacked on or under other IP Office
modules. The module can be wall or rack mounted using the IPO IP500 RACK MNTG KIT V3 .
Width: 445mm/17.5". Depth: 245mm/9.7". Height: 71mm/2.8".
Unboxed: 3.5Kg/7.8lbs. Boxed: 4.8Kg/10.8lbs. (Based on DS30A RJ21)
· Green On = Phone detected.
The center LED on all external expansion modules is used to indicate the overall state of the module as
follows:
· Red flashing = Module starting up/Loading firmware.
· Red on = Error.
· Green on = Module okay.
· Green flashing = Module starting up/Loading firmware (IP500 DS16A/30A module only).
To Next Page
Loading...
