Installing IP500/IP500 V2 Page 421
15-601042 Issue 28c (19 August 2013)IP Office 9.0
System Components: Hardware Software Compatibility
10.18 Hardware PCS Levels
Each item of IP Office hardware has a Product Change Status (PCS) level. This is usually included on the label on the
hardware.
The PCS level is increased each time a change is made to a component of that piece of hardware. For example the PCS
level will be increased when a component is replaced by one from a different supplier.
Normally changes to a PCS level are not important and items of the same hardware but with different PCS levels are still
identical in operation and can be interchanged. However, there are some exceptions as listed below.
· IP500 Analog Trunk Card V1
These cards are support by IP Office Release 4.0 and higher. However, PCS10 and higher cards are only supported
in systems running IP Office Release 6.1(20), 7.0(12) or 8.0 and higher. Refer to IP Office Technical Tip 237.
· IP500 ATM4 Combination Card V1
These cards are supported by IP Office Release 6.0 and higher. However, PCS04 and higher cards are only
supported in systems running IP Office Release 6.1(20), 7.0(12) or 8.0 and higher. Refer to IP Office Technical Tip
237.
· IP406 V2 Control Unit
For this type of control unit to run IP Office Release 4.0 or higher software up to IP Office Release 6.1, the control
unit must be PCS 8 or higher.
· IP400 DS30 and 4424D Telephone Support
A maximum of sixteen 4424D telephones are supported on an IP400 DS30 V2 unless PCS05 or higher. PCS05 and
higher units can support up to twenty-seven 4424D telephones.
10.19 TAA
Those items labeled as TAA are compliant with the requirements of the Trade Agreements Act which is a pre-requisite for
federal purchases in the United States of America. Unless otherwise stated, the TAA variants of equipment are physically
and functionally the same as the non-TAA variants.
To Next Page
Loading...
