3. Select the call on hold that you want to add to the conference.
4. Press Resume to take the call off hold.
5. Press one of the following:
• Join
• Conf
Putting a conference call on hold and resuming a call
About this task
Use this procedure to put a conference participant on hold, while the others continue in the
conference call.
Procedure
1. Press Hold during a conference call.
2. Do one of the following:
• Press Resume.
• Press OK.
• Select the call appearance to resume the conference call.
Dropping the last participant from a conference call
About this task
Use the following procedure to drop the last participant added to the conference call. Once you
drop the last added participant, you cannot use the procedure to drop other participants. The
phone plays an error tone if you try to use the drop method again. If you add another participant
after dropping the last added participant, you can use the drop method again to drop this
participant.
Procedure
1. From the Phone screen, select your active call.
2. Press Drop when the conference is up.
The phone drops the last added person from the conference.
Viewing the details for a conference
About this task
Use this procedure to view details of the participants in a conference call.
Note:
Depending on which server your extension is configured in, you might not see the details of a
conference. If you are not able to view the details of a conference, contact your system
administrator.
Call operations
May 2018 Using Avaya J169/J179 IP Phone SIP in third-party call control setup 34
Comments on this document? infodev@avaya.com
To Next Page
Loading...
