Extending a call to your cell phone
About this task
Use this procedure to forward an ongoing call to your cell phone by using the EC500 feature.
When you answer the extended call on your cell phone, the call remains active on your office
phone. Later you can switch back to your office phone to continue the call.
Before you begin
• Ensure that the feature is activated by the administrator.
• Ensure that EC500 is configured on your mobile phone.
• Ensure that you administrator sets your personal phone number as your destination number.
Procedure
1. Press Main menu, and scroll to Features.
2. Press one of the following:
• Select
• OK
3. Scroll to Extend Call, and press Select.
4. Press OK.
You will receive a call on your cell phone to answer the extended call.
Activating Send All Calls
About this task
When Send All Calls (SAC) feature is on, your incoming calls go directly to a predefined coverage
number, typically your voice mail. Incoming calls ring once at your extension and then go directly
to a number which is set by your system administrator.
You can also turn Send All Calls on or off by using the phone Features list.
Note:
Do not enable the SAC feature in case you selected the cover all option for the coverage path.
Enabling both features at the same time can cause duplicate entries in the call log.
Procedure
1. Navigate to the Features screen.
2. Scroll to choose Send All Calls.
3. Press Select or the corresponding line button to activate the feature.
Advanced features
May 2018 Using Avaya J169/J179 IP Phone SIP in third-party call control setup 40
Comments on this document? infodev@avaya.com
To Next Page
Loading...
