If you switch Network config from Manual to Auto, press Save and then do either of
the following:
• If the currently-connected network is the same as the pre-configured network that
your administrator has set up, the phone will not restart and stay in the Auto mode.
• If the currently-connected network is not the same as the pre-configured network
that your administrator has set up, the phone will prompt you for permission to
restart before connecting to the pre-configured network.
Related links
Setting the network mode on page 112
Authenticating XSI
About this task
Authenticate XSI in the following cases:
• XSI fails when account is configured on BroadWorks portal and the BroadSoft user id does
not match the SIP authorization username.
• XSI fails when SIP authorization method is disabled on BroadSoft for some reason.
Procedure
1. Press Main menu.
2. Scroll to Settings, and press Select.
3. Scroll down to XSI Authentication, and press one of the following:
• Select
• OK
• The corresponding line key
4. In Authentication method: Press Toggle to choose one of the method:
• SIP: when the credentials fail authentication on the BroadWorks portal.
• Web: when SIP authorization method is disabled on BroadSoft.
- Enter the web access password.
5. Press Enter.
Authenticating XSI
October 2019 Using Avaya J169/J179 IP Phone in an Open SIP environment 115
Comments on this document? infodev@avaya.com
To Next Page
Loading...
