Avaya J189 - Making a call to a monitored user; Call Transfer to a monitored user; Making a blind transfer to a monitored user

2. To transfer the call to another phone, press Bridge on your phone.
If the MDA phone that is joining the call uses a different signaling mode address family, you
might notice the Limited Service icon appear on your device for a brief moment. After the
MDA phone that is joining the call switches to using the signaling mode address family of
the active call, the icon disappears.
Related links
Adding a participant to no hold conference on page 95
Multiple Device Access on page 92
Using URI dialing to make a call
About this task
Use this procedure to dial an extension with the format username@host.The host name includes
one of the following:
• IPv4 address
• Fully qualified domain name
Before you begin
Ensure that the Manual dialing feature is enabled on your phone.
Procedure
1. To enter the URI extension, use the relevant input method for uppercase and lowercase
letters and numbers.
2. Press the Call soft key to make the call.
Related links
Setting the dialing mode on page 106
Making a priority call
About this task
Use the Priority Calling feature to provide a special type of internal call alerting for the users. The
called party hears a distinctive ringing when the calling party uses Priority Calling.
The call rings even at an extension with Do not disturb enabled.
Procedure
1. Press the Main menu.
2. Scroll to Features, and press Select.
Using URI dialing to make a call
April 2021 Using Avaya J189 SIP IP Phone in Avaya Aura
®
93
Comments on this document? infodev@avaya.com