Pre-Installation Checklist
Issue 1 August 2010 13
3. The following circuit packs are installed on the switch:
●
TN2602 or TN2302IP Media Processor circuit pack. Sites with a TN2302 IP Media
Processor circuit pack are strongly encouraged to install a TN2602 circuit pack to
benefit from increased capacity.
●
TN799C, or D Control-LAN (C-LAN) circuit pack.
!
Important:
Important:
Release 6.0 or greater requires TN799C V3 or greater C-LAN circuit
pack(s). For more information, see the Communication Manager Software
and Firmware Compatibility Matrix on the Avaya support Web site http://
www.avaya.com/support.
4. The Avaya Media Server is configured correctly, as described in the Avaya one-X™
Deskphone H.323 Administrator Guide and Avaya Communication Manager documentation.
Both documents are available at:
http://www.avaya.com/support
.
5. The DHCP server and application are administered as described in the Avaya one-X™
Deskphone H.323 Administrator Guide.
6. The HTTP/HTTPS server and application are administered as described in the Avaya
one-X™ H.323 Administrator Guide.
7. The upgrade script and application files from the Avaya Support Web site,
http://www.avaya.com/support
, are loaded correctly on the HTTP/HTTPS server.
8. If applicable, the DNS server is administered as described in the Avaya one-X™ Deskphone
H.323 Administrator Guide.
9. If applicable, the WML server is administered as described in the Avaya one-X™
Deskphone H.323 Administrator Guide.
Notes:
- Any or all of the server applications mentioned in items 5.-9. can be co-resident on the same
hardware, subject to the specific restrictions of each individual application.
- See the Avaya one-X™ Deskphone H.323 Administrator Guide for more information about:
Note:
●
administering other network equipment,
●
administering applications like firewalls, and
●
information about topics like port utilization.
Requirements to Verify for Each IP Telephone
10. You have an extension number and an Avaya Communication Manager security code
(password) for each applicable IP telephone. If your call server supports unnamed
registration, and the telephone settings file allows unnamed registration, you do not need
to provide an extension or password for the telephone. However, if you do not provide an
extension or password, the telephone will have very limited telephone functionality.
(For information, see Unnamed Registration
on page 26.)
11. A Category 5e LAN jack is available at each telephone site and a Category 5 modular line
cable is available for connecting the deskphone to the Ethernet wall jack.
12. Electrical power may be provided to each telephone by a Telephone Power Module (which
must be ordered separately). For PoE Input connection, use only with UL listed I.T.E.
equipment with PoE output. If the LAN will supply IEEE-standard power (Power over
Ethernet) to the telephone, no power module is required.
13. 1 Category 5e modular line cord is available for the connection between the IP deskphone
and the PC, if applicable.
Verify These Network Requirements (continued)
To Next Page
Loading...
Need help?
General
