Local Administrative (Craft) Options
44 9600 Series H.323 Deskphones Release 6.0 Installation and Maintenance Guide
1. When you select DEBUG from the Craft Local Procedure Screen, the following text
displays:
where the setting is the text string associated with the current system value of NVDEBUG,
defined as:
●
"On" if the NVDEBUG system value is "1".
●
"Off" if the NVDEBUG system value is "0".
2. Press Change to toggle the selected setting from On to Off or vice versa.
3. Press Save to store the new setting.
The telephone saves the new value and the telephone initiates a reset.
Group Identifier
Note:
Note:
When updating local (Craft) procedures from a touchscreen deskphone, touching
the line you want to change or the applicable softkey produces the same result as
selecting a line and pressing the applicable softkey on a non-touchscreen IP
Deskphone.
Use the following procedure to set or change the Group Identifier.
Note:
Note:
Perform this procedure only if the LAN Administrator instructs you to do so.
For more information about groups, see The GROUP Parameter
on page 57.
1. When you select GROUP from the Craft Local Procedure Screen, the following text
displays:
where the setting is the current system value of NVGROUP.
2. Enter a valid Group value (0-999).
3. Press Save to store the new setting and redisplay the Craft Local Procedure screen.
Debug Mode On
Current setting:
New Setting:
To Next Page
Loading...
Need help?
General
