Entering Data for Administrative Options
Issue 1 August 2010 31
3. Press # when password entry is complete.
The entry is compared to the PROCPSWD value. If they match, the telephone displays the
Craft Local Procedure screen, "Select procedure and press Start."
4. For all non-touchscreen phones, use the navigation arrows to scroll to and highlight the
local procedure you want, then press Start or OK. Or scroll to the procedure you want and
press the corresponding line button. For touchscreen phones, scroll to the local procedure
you want if it not already displayed then touch the line on which the local procedure you
want appears.
During Normal Telephone Operation:
1. Invoke all local procedures by pressing the Mute button, entering the local (dialpad)
procedure password (0 to 7 numeric digits), then pressing the # button. If you are using a
touchscreen phone and need to backspace during password entry, use the Contacts button;
for non-touchscreen phones, use the left arrow button or the designated softkey.
A 6-second timeout is in effect between button presses after pressing the Mute button. If
you do not press a valid button within 6 seconds of pressing the previous button, the
collected digits are discarded. In this case, no administrative option is invoked.
The entry is compared to the PROCPSWD value. If they match, the telephone displays the
Craft Local Procedure screen, and prompts "Select procedure and press Start."
2. For non-touchscreen phones, use the navigation arrows to scroll to and highlight the local
procedure you want, then press Start or OK. Or scroll to the procedure you want and press
the corresponding line button. For touchscreen phones, scroll to the local procedure you
want if it not already displayed then touch the line on which the local procedure you want
appears.
Entering Data for Administrative Options
This section applies to all 9600 Series IP Deskphones and describes how to enter data for
administrative options.
1. With the exception of a touchscreen deskphone, the first application line on any screen is
automatically highlighted (selected) when the phone displays the screen. To select the item
on that line, press the appropriate softkey at the bottom of the screen, for example, Change
or Save, or the OK button. To select a different line, use the down or up navigation arrows
to change the line focus. When the desired line is highlighted, then press a softkey or OK to
select that line. For a touchscreen deskphone, touching the desired line produces the same
result.
2. Attempts to enter invalid data are rejected and the telephone emits an error beep.
To Next Page
Loading...
Need help?
General
