Pre-Installation Checklist for Static Addressing
Issue 1 August 2010 37
5. Press/touch Save to store the new setting and redisplay the Craft Local Procedure screen.
Pre-Installation Checklist for Static Addressing
Before performing static programming of address information, verify that all the requirements
listed in the Verify These Network
Requirements section of the Pre-Installation Checklist are
met. You do not have to consider item 4.
on page 13, as it refers to the DHCP server. In
addition, you must have the values for the following parameters. Failure to do so can cause
data entry errors that prevent the telephone from working. Such errors can also have a negative
impact on your network. Print copies of this checklist for each subnet.
Static Addressing Installation
The usual way to assign IP Addresses to IP telephones is the automatic method described in
P
ower-Up and Reset Operation (Dynamic Addressing Process) on page 19. There might be
times, however, when manual assignment of IP Addresses is desired.
!
CAUTION:
CAUTION:
Static addressing is necessary when a DHCP server is unavailable.
Because of the increased opportunities for text entry errors associated with static
addressing, Avaya strongly recommends that a DHCP server be installed and
static addressing avoided.
!
Important:
Important:
IPv6 operation is limited to a specific customer set and is not for general use.
Note:
Note:
When updating local (Craft) procedures from a touchscreen deskphone, touching
the line you want to change or the applicable softkey produces the same result as
selecting a line and pressing the applicable softkey on a non-touchscreen IP
Deskphone.
1. The IP Address of the media server.
2. The IP Address of the gateway/router.
3. The IP netmask.
4. The IP Address of the HTTP server.
To Next Page
Loading...
Need help?
General
