Restart the Telephone
Issue 1 August 2010 49
●
Resets the 802.1X ID and Password to their default values.
●
Resets call server values to their defaults.
●
Deletes any entries in the Redial buffer.
●
Does not affect user-specified data and settings like Contacts data or the telephone login
and password. To remove this type of data, see the C
lear Procedure on page 41.
Restart the Telephone
Note:
Note:
When updating local (Craft) procedures from a touchscreen deskphone, touching
the line you want to change or the applicable softkey produces the same result as
selecting a line and pressing the applicable softkey on a non-touchscreen IP
Deskphone.
Use the following procedure to restart the telephone.
1. When you select RESTART PHONE from the Craft Local Procedure Screen, the telephone
displays the following text:
2. Press Cancel to return to the Craft Local Procedure screen without restarting the
telephone. Press Restart to proceed with the registration steps covered in the P
ower-Up
and Reset Operation (Dynamic Addressing Process) on page 19.
A restart does not affect user-specified data and settings like Contacts data or the
telephone login and password.
The remainder of the restart procedure depends on the status of the boot and application
files.
Signaling Protocol Identifier
Note:
Note:
When updating local (Craft) procedures from a touchscreen deskphone, touching
the line you want to change or the applicable softkey produces the same result as
selecting a line and pressing the applicable softkey on a non-touchscreen IP
Deskphone.
Press Restart to confirm.