Figure 75: Configuring SIP settings
2. Enter your system’s name (alias) and the SIP server’s information, used to register and
authenticate the XT Series with the SIP server:
Table 24: Configuring SIP-related parameters
Parameter Description
User Enter the system name (alias). The system is registered
to the SIP server under this name.
When connecting over SIP, this name is displayed on the
monitors participating in the videoconference (for
example, John-Smith, or 9th-Floor-Room) .
Authentication Name If necessary, enter the name for authenticating the XT
Series with the SIP server. It can be the same as the
User parameter.
Authentication Password If necessary, enter the password for authenticating your
XT Series with the SIP server.
Use Server 1
Use Server 2 (Optional)
Use Server 3 (Optional)
Enable registering the system to the SIP server by
selecting Yes for each server you are defining.
For redundant SIP deployments, you can enter
information for up to three SIP servers. The XT Series
uses Server 1 as the default SIP server. If Server 1 fails,
the system uses Server 2, and so on.
Table continues…
Registering the XT Series to a SIP Server
April 2015 Avaya Scopia
®
XT Series Deployment Guide 109
Comments? infodev@avaya.com
To Next Page
Loading...
