Figure 55: Examining the image position
3. Press 1 to highlight the triangle in the top left corner in blue.
4. Use the arrow keys to position the image, so all sides of the white border of the triangle are
visible in the screen, then press ok/menu.
5. Press 2 to highlight the triangle in the bottom right corner in blue.
6. Adjust the image position in the same way, until all sides of the triangle border are visible,
then press ok/menu.
7. To continue with the Quick Setup Wizard, select Next (see
Configuring Basic Network
Settings on page 87).
Related Links
Configuring Basic Settings with the Quick Setup Wizard on page 83
Configuring Basic Network Settings
About this task
This procedure describes how to set up the basic network settings and the IP address of the XT
Series as part of the Quick Setup Wizard. To modify advanced network settings, see
Configuring
Advanced Network Settings on page 116.
Procedure
1. Access the Quick Setup Wizard from the endpoint, as described in Configuring Basic
Settings with the Quick Setup Wizard on page 83, and skip to this step.
Configuring Basic Settings with the Quick Setup Wizard
April 2015 Avaya Scopia
®
XT Series Deployment Guide 87
Comments? infodev@avaya.com
To Next Page
Loading...
