Avaya Scopia XT Executive - Configuring the Screen Saver to Start Automatically

Figure 62: Setting the time zone
Table 18: Configuring time zone related settings
Field Name Description
Time zone list Select the time zone to which the system belongs.
Enable daylight time Choose whether to enable daylight savings time.
Start (dd/mm) Set the day and month to indicate when daylight saving
time starts.
Stop (dd/mm) Set the day and month to indicate when daylight saving
time ends. If this is earlier than the start time, it assumes
the following year.
3. From the web interface only, select Save.
Related Links
Configuring Basic Settings with the Quick Setup Wizard on page 83
Configuring the Screen Saver to Start Automatically
About this task
The screen saver helps to protect the endpoint's monitor from burn-in without switching it off. For
Scopia
®
XT Executive with computers running the Scopia
®
XT Control utility, the screen saver does
not activate when using the computer while the endpoint is dormant. In this case, use the
computer's screen saver functionality.
Procedure
1. Access the screen saver settings. From the endpoint's main menu, select Configure >
General. From the XT Series web interface, select the Basic Settings tab.
Configuring Basic Settings with the Quick Setup Wizard
April 2015 Avaya Scopia
®
XT Series Deployment Guide 95
Comments? infodev@avaya.com