If you deployed TLS with a security certificate for this device, a change in the IP address requires
creating a new certificate (see Securing Connections to the XT Series Using TLS on page 160).
Before you begin
If configuring from the endpoint, you must first enable advanced configuration, as described in
Enabling Advanced Maintenance on the XT Series on page 112.
Procedure
1. Access the advanced network settings. From the XT Series web interface, select
Administrator Settings > Networks > Preferences > General. From the endpoint's main
menu, select Configure > Network.
Figure 80: Enabling IPv6 mode
2. Set the Use IPv6 field to enable or disable IPv6 support.
3. From the web interface only, select Save.
4. Access the IP address. From the endpoint's main menu, select either GLAN 1 or GLAN 2.
From the XT Series web interface, select GLAN 1 or GLAN 2 > Addresses.
Figure 81: Configuring IP addresses from the web interface
5. Enter the following fields:
Configuring Advanced Network Settings
April 2015 Avaya Scopia
®
XT Series Deployment Guide 117
Comments? infodev@avaya.com
To Next Page
Loading...
