Avaya Scopia XT Executive - Page 140

- All users (inetOrgPerson entities) must be located under an organizational unit (ou) in the
LDAP tree. For example, ou=people.
- All endpoints (commObject entities) must be listed under an organizational unit called
h323Identity if they are to work with H.323, and SIPIdentity if they are to work as SIP
endpoints.
Since the XT Series works both as an H.323 and a SIP endpoint, all XT Series commObject
s should be listed under both organizational units.
- Each endpoint is represented by a commObject with its commUniqueId. Each
commObject contains the details of accessing this endpoint, and the user associated with it.
Define the following fields:
Table 41: commObject fields
Field Value Comments
objectClass commObject Use this exact value
objectClass h323Identity Use this exact value
commOwner uid=<x>,ou=people,dc=company,d
c=com
The user ID associated with
this endpoint
h323IdentityEndpointType Terminal Use this exact value for H.
323 endpoints only
h323IdentitytransportID <ip address>
At least one of these fields
must be defined for an H.
323 endpoint.
h323IdentitytransportDigits <E.164 dial number>
h323IdentitytransportNumber <H.323 alias>
h323Identityh323-ID <H.323 alias>
SIPIdentitySIPURI <URI address of SIP endpoint> SIP endpoints only.
- Each user (inetOrgPerson entity) must have its commURI field pointing to the user's
endpoint (commObject ID). For example:
ldap://123.456.789.012/ou=h323identity,dc=company,dc=com??sub?(commUniqueId=6) XT5000
where commUniqueId refers to the commObject ID.
A centralized solution like Scopia
®
Management enables synchronizing the same list of contacts
across all the endpoints in your organization, and has other benefits like remote centralized
upgrading and backing up of all endpoints in your video network. You can configure the XT Series to
use Scopia
®
Management as the LDAP directory also from the Avaya Scopia
®
Management
administrator portal (for details, see the Administrator Guide for Avaya Scopia
®
Management).
Before you begin
If configuring from the endpoint, you must first enable advanced configuration, as described in
Enabling Advanced Maintenance on the XT Series on page 112.
If you are using Avaya Scopia
®
Management as the LDAP directory, you must associate LDAP
contacts to video endpoints; otherwise these contacts are not displayed on the XT Series. Each
LDAP contact on the XT Series can only be mapped to a maximum of ten video endpoints.
Advanced Configuration of the XT Series
140 Avaya Scopia
®
XT Series Deployment Guide April 2015
Comments? infodev@avaya.com