Avaya Scopia XT Executive - Page 66

Procedure
1. If your computer has a DVI port, connect it to the DVI port on the XT Codec Unit.
Alternatively, use the supplied DVI-VGA adapter to connect a VGA cable from the adapter to
the computer's VGA port.
Figure 42: Connecting a computer's display to the XT Series
2.
Connect the computer audio to the audio-in
port on the XT Codec Unit, which supports
both analog and digital optical audio.
Important:
Participants in the meeting can hear your computer’s audio even if you mute the audio
on the XT Series.
Figure 43: Connecting a computer's audio to the XT Series
When you connect a computer's audio output to the XT Series, the echo cancellation for this
analog input is disabled by default (see Configuring Microphones on page 104).
3. Set the computer's resolution by accessing the operating system graphics settings.
4. Select your screen resolution and refresh rates from the list of supported settings (see
Table
10: Supported computer monitor resolutions and refresh rates on page 67).
Setting Up the XT Series Hardware
66 Avaya Scopia
®
XT Series Deployment Guide April 2015
Comments? infodev@avaya.com